Denso BHT-6000 - Manual (Page 12)

x
Benzine Thinner
Take care of
me with a dry
soft cloth.
NO WAY!!
■ Proper Care of the BHT and CU
Clean the housing, charge terminals, and battery cartridge terminals with a dry, soft
cloth. (When taking care of the CU-6000, unplug the AC adapter from the wall socket
for safety.)
• Never use benzene, alcohol, or other or-
ganic solvents. The housing may be
marred or the paint may come off.
• Never rub or strike the liquid crystal dis-
play (LCD) with anything hard. The LCD
surface will be easily scratched or bro-
ken.
• When cleaning the keypad, do not scrub
the surface too hard, and do not pull on
the keys. Doing so may break the keys
or cause the keypad to dislocate.
• If the BHT or CU becomes smudged, moisten a soft cloth with neutral detergent and
wring it out thoroughly. Wipe the BHT or CU with the cloth and then go over it
again with a dry cloth.
Dust or dirt accumulating on the clear plate of the bar-code reading window will affect
reading performance. If you use the BHT-6000 in dusty areas, therefore, periodically
check the clear plate of the bar-code reading window and clean it if dusty.
• To clean the plate, first blow the dust away with an air brush. Then wipe the plate
with a cotton swab or the similar soft one gently.
• If sand or hard particles have accumulated, never rub the plate; doing so will
scratch or damage it. Blow the particles away with an air brush or a soft brush.
■ Limited Warranty on Software Products
In no event will DENSO WAVE be liable for direct, indirect, special, incidental, or
consequential damages (including imaginary profits or damages resulting from inter-
ruption of operation or loss of business information) resulting from any defect in the
software or its documentation or resulting from inability to apply the software or its
documentation.