Denso BHT-6000 - Manual (Page 140)

125
Chapter 4. Error Messages
Execution program not selected
■ Problem
No user program has been selected as an execu-
tion program to be run when the power is turned
on.
■ Solution
Operate the BHT-6000 in System Mode and select
an execution program in the SET SYSTEM menu.
(For the selecting procedure, refer to Chapter 2,
Subsection 2.5.3, [4.1].)
No execution
program selected
Contact your
administrator.
Resume data saving error
■ Problem
When the power was turned off, the system failed
to save resume data although the resume function
had been set to ON.
The BHT-6000 displays this error message
for two seconds and automatically runs the
execution program from the point of start-up.
NOTE
Resume failure !
Program restarts
automatically.