Denso BHT-6000 - Manual (Page 58)

43
Chapter 2. Getting Started the BHT-6000 and System Mode
[4.1] Setting an execution program
Selecting "1: PROGRAM" on the SET SYSTEM menu
calls up the screen shown at left.
Reversed is the current setting.
Use the F5 and F6 keys to move the cursor to a
desired execution program to be run when the
power is applied, and then press the ENT key.
To return to the SET SYSTEM menu, press the
C key.
The RAMed files are shown as "A:FILE NAME;" the
flash-ROMed files are as "B:FILE NAME."
SET EXEC PROGRAM
A:EASYPACK.PD3
A:SAMPLE1.PD3
A:SAMPLE2.PD3
B:SAMPLE3.PD3
B:SAMPLE4.PD3
SET EXEC PROGRAM
****************
*NO FILE EXISTS*
****************
If no files program are stored in the memories, the
screen shown at left will appear.
To return to the SET SYSTEM menu, press the C
key.