Dodge 2008 Nitro User Manual
Page 140
NOTE:
• Some gate operators and garage door openers may
require you to replace Step #3 with procedures noted
in the “Gate Operator/Canadian Programming” sec-
tion.
• After training a HomeLink channel, if the garage
door does not operate with HomeLink
and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so,
proceed to the heading “Programming A Rolling Code
System.”
4. Press and hold the just-trained HomeLink
button
and observe the indicator light.
If the indicator light stays on constantly, programming is
complete and the garage door (or device) should activate
when the HomeLink
button is pressed.
If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, continue with program-
ming for Rolling Code.
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the “learn” or “training” button.
This can usually be found where the hanging antenna
wire is attached to the garage door opener motor (it is
NOT the button normally used to open & close the door).
140
UNDERSTANDING THE FEATURES OF YOUR VEHICLE