Dodge 2008 Nitro - Manual (Page 21)

On electronic vehicle information center (EVIC)
equipped vehicles, refer to “Remote Key Unlock,” under
“Personal Settings (Customer Programmable Features),”
under “Electronic Vehicle Information Center (EVIC)” in
Section 4 of this manual
On non-EVIC equipped vehicles, perform the following
steps:
1. Press and hold the “Lock” button on a programmed
(i.e. functional) key fob for at least 4 seconds, but not
longer than 10 seconds. Then, press and hold the “Un-
lock” button while still holding the “Lock” button.
2. Release both buttons at the same time.
3. Test the feature from outside the vehicle by pressing
the “Lock” and “Unlock” buttons on the key fob.
4. Repeat these steps if you want to return this feature to
its previous setting.
NOTE: Pressing the “Lock” button on the key fob while
you are inside the vehicle will activate the Security
Alarm. Opening a door with the Security Alarm activated
will cause the alarm to sound. Press the “Unlock” button
to deactivate the Security Alarm.
To Lock the Doors and Liftgate
Press and release the “Lock” button on the key fob to lock
all doors and the liftgate. If the ignition is OFF when the
doors are locked, the parking lights will flash once and
the horn will chirp once.
Sound Horn with Lock
This feature will cause the horn to chirp when the doors
are locked with the key fob. This feature can be turned on
or off. To change the current setting, proceed as follows:
• On electronic vehicle information center (EVIC)
equipped vehicles, refer to “Sound Horn with Lock,”
under “Personal Settings (Customer Programmable
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 21
2