Installation – Desa CDCFNRA User Manual

Page 19

Advertising
background image

www.desatech.com

116658-01A

19

OPTIONAL WIRELESS HAND-HELD
REMOTE CONTROL ACCESSORIES

Installing Receiver
1. Disconnect wires from the control valve (see

Figure 26).

2. Locate the battery clip mounted on the back

of the receiver (see Figure 27).

3. Slide 9-volt battery (not included) through the

clip.

4. Attach the terminal wires to the battery (see

Figure 27).

5. Connect wires from remote receiver to control

valve as shown in Figure 28.

6. Install remote receiver unit onto remote/

blower bracket using screws provided (see

Figure 28).

Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote

control unit.

2. Attach terminal wires to the battery (not includ-

ed). Place battery into the battery housing.

3. Replace battery cover onto remote control unit.

INSTALLATION

Continued

Figure 26 - Disconnecting Wires From

Control Valve

Figure 27 - Attaching Battery to Receiver

Battery Clip

9-Volt
Battery

Receiver

Terminal
Wires

Figure 28 - Installing Remote Receiver

Remote
Receiver

White Wire to
TH Terminal on
Control Valve

Red Wire to
TPTH Terminal on
Control Valve

Figure 29 - Installing Battery in Hand-

Held Remote Control Unit

OPTIONAL WALL MOUNTED
THERMOSTAT - GWMT1

WARNING: Read and fol-

low installation instructions.

Installation should be done by

a qualified installer familiar with

low-voltage wiring procedures.

WARNING: Do not connect

this thermostat to any electrical

source! Electrical shock and/or

fire hazard will occur.

1. Remove jumper wire from control valve (see

Figure 26).

2. Connect one terminal of 25 ft. wire to the

“TH” terminal on the control valve. Connect

the other terminal to the “THTP” terminal on

the control valve. See Figure 30, page 20.

3. Route the 25 ft. wire to a convenient location

to mount your thermostat (no outside wall).

IMPORTANT:

The wire may be shortened

but must not be lengthened.

The thermostat should be mounted 54" above

the floor in a location where there is good

air circulation. Avoid heat sources such as

lamps, direct sunlight, fireplace, or heat and

air conditioning ducts.

9-Volt Battery

Battery
Housing

Battery
Cover

Terminal
Wires

Remote Control Unit

Advertising