3DLABS WILDCAT REALIZM 100 - Manual (Page 10)

S ETUP
3Dlabs Wildcat Realizm Graphics Accelerator User's Guide 10
2. Locate an unused system power supply cable. If your power supply cable cannot reach the card,
you will have to purchase a longer cable.
3. Connect the power cable to the graphics card. Remove the anti-static wrist strap, if used, and
replace the cover on your system.
4. Reconnect the power cord.
If you are upgrading the graphics card in your system
NOTE: These instructions may be different from how you normally
upgrade your graphics card or other devices, but have been
found to be the best method of insuring a successful
installation of your new hardware and software.
1. Uninstall the drivers for your old graphics card. Refer to your old graphics card’s documentation
or Help files for instructions on removing or uninstalling the old graphics card’s driver software.
2. Remove the existing graphics card from your system. To install your Wildcat Realizm Graphics
Accelerator Card, see the hardware installation instructions above.
3. Install the Wildcat Realizm Graphics Accelerator Card driver software; see “Installing the Driver
Software” later in this chapter.