3DLABS WILDCAT REALIZM 100 - Manual (Page 13)

S ETUP
3Dlabs Wildcat Realizm Graphics Accelerator User's Guide 13
NOTE: If your monitor does not have a built-in video cable, use a
shielded video cable with either a DVI-I receptacle or a 15-
pin VGA video connector (with adapter) at one end for the
video output port on the card, and the appropriate
connectors at the other end for the video input port on the
monitor. See the documentation delivered with your monitor
for more information.
NOTE: If you ordered the Wildcat Realizm video card with a system,
it was installed and configured before shipment. See
Chapter 3, “Using the Video Card," for instructions on
adjusting the resolution, color depth, and refresh rate.
Attaching a Stereo Device
Power off your system and connect the stereo hardware to the round, stereo connector on the card. See
the documentation that came with your stereo hardware for information on how to use stereoscopic
display. Plug in and start up your system, including peripherals, and log on to your operating system.
NOTE: To configure the display settings for stereo display, see
Chapter 3, “Using the Video Card” for step-by-step
instructions.
3-Pin Mini-DIN Stereo Connector
DVI VGA