3DLABS WILDCAT REALIZM 100 User Manual
Page 9
S
ETUP
3Dlabs Wildcat Realizm Graphics Accelerator User's Guide
9
1. Locate the power connection on the Wildcat Realizm 800 (see diagram below). Connect the
single end of the power Y cable to the Wildcat Realizm 800.
2. Locate a single connector each on two independent system power supply cables. The cables
must be independent of one another and the connectors must be the first ones closest to the
power supply.
3. Plug each of the two connectors from the power Y cable (the one you plugged into the Wildcat
Realizm 800) into the two system power supply cables.
4. Remove the anti-static wrist strap, if used, and replace the cover on your system.
5. Reconnect the power cord.
Connecting power to the Wildcat Realizm 200 or 100
WARNING: F
AILURE TO FOLLOW THE INSTRUCTIONS BELOW WILL JEOPARDIZE THE FUCNTIONALITY OF THE
GRAPHICS CARD
.
1. Locate the power connection on the Wildcat Realizm 200 or 100 (see diagram below).