3DLABS Oxygen GVX210 - Manual (Page 12)

Installation
3Dlabs Oxygen GVX210 User's Guide 2
Getting Ready
To successfully use your new Oxygen GVX210 card, you must install the card and the accompanying driver
software. Whether you install your new card or the driver first depends on whether a video card is already
present in your system.
If there is a video card in your system: Uninstall the drivers for the existing card, then install the Oxygen
driver. Once the new driver is loaded, remove the old card and install your Oxygen GVX210 card. The
instructions for uninstalling an old driver and installing the new driver begin on page 6.
If there is not a video card in your system: Install your new card as described in the Installing Hardware
section, below, then install the driver.
Once the basic installation is complete, you can choose to install the SoftEngine and Colorific enhancements
as described on page 6.
Note: Be sure to register your new card using one of the options described on page 7.
Before You Start
Take every possible precaution against static electricity as you prepare to install the card: static can
damage components. We have included an anti-static wrist strap for you to wear while installing the
hardware: you should also try to work in a static free area (such as on a tile floor rather than carpet).
You might even consider wearing special ESD, or at least rubber-soled, shoes.
Save any work in progress and exit any open applications. Always back up your system before you
install new hardware or software.
Have your anti-static strap and a Philips-head screwdriver ready.