3DLABS Oxygen GVX210 - Manual (Page 28)

Software Configuration
3Dlabs Oxygen GVX210 User's Guide 18
Configuring Multiple Monitors
If your operating system is Windows NT or Windows 2000, you can configure your system to support two
monitors by clicking the Enable 2
nd Monitor Output checkbox on the Setup screen of the 3Dlabs Display
Control Panel. (Dual-monitor support is not available for Windows 98.)
To configure a second monitor
1. In the Display Properties Control Panel, click the Settings tab.
2. Click List All Modes.
3. In the List of Valid Modes, click a resolution and then click OK. Select a resolution that is twice the
width of your current resolution. For example, if your current resolution is 1024 x 768, select 2048 x
768, 75 Hertz for your new resolution.
4. On the Display Properties Panel, click Test. This tests the new mode on the second monitor screen
for five seconds.
5. Click OK to test the new mode.