3DLABS Oxygen 402 User Manual
Page 25
Installation and User’s Guide
19
6.
Install the Oxygen card in an empty PCI slot, following the
instructions provided by the computer manufacturer for installing
PCI option cards. You should always handle your Oxygen card by
its edges.
NOTE:
The PCI slot in which you install your Oxygen card must be
bus-master capable. Some PCs do not allow PCI bus-master
capability from all PCI slots, so be sure to check your motherboard
or PC documentation before selecting a slot for your Oxygen card.
7.
Make sure you screw the faceplate of the Oxygen card to the
system chassis to provide mechanical support and proper
grounding. This step is critical to the proper operation of your new
card. You may now remove the anti-static wrist strap and save it
for future use.
8.
Connect the video cable from your monitor to the monitor video
connector on your card (Figure 12).
Figure 12:
Monitor Video Connector
9.
If you have the appropriate stereoscopic viewing hardware and
specially configured Oxygen 202 or Oxygen 402, connect the stereo
cable to the stereoscopic infrared transmitter and to the
stereoscopic viewing connector shown (Figure 13). You can also
find more information on stereo viewing in the
Stereo 3D
Technical Overview section on page 54.
Figure 13:
Stereoscopic Viewing Connector