ADLINK cPCI-7434 - Manual (Page 20)

12
•
Getting Started
For cPCI-743X products (with and without rear I/O)
1. Read through this manual, and setup the jumper according to your
application needs.
2. Turn off your computer and all accessories (printer, modem, monitor,
etc.) connected to the computer.
3. Remove the cover from the slot of your cPCI computer.
4. Select a 32-bit cPCI expansion slot on the back plane for cPCI-743X
card.
5. Before handling the cPCI-743X card, discharge any static buildup
from your body by touching the metal casing of the computer. Hold
the edge and do not touch the com ponents.
6. Position the board into the cPCI slot you selected.
7. Secure the card on the back plane by using screws removed from the
slot.
CAUTION!! Don’t put cPCI-743XR (rear I/O) cards into the cPCI back plane
of other manufacturers because the rear I/O definition might be
different, and permanent damage could happen.
2.5 Device Installation for Windows Systems
Once Windows 95/98/2000 has started, the Plug and Play functions of the
Windows system will find and locate the new NuDAQ/NuIPC card. If this is
the first time a NuDAQ/NuIPC card is installed in your Windows system , you
will be prompted to input the device information source. Please refer to the
“Software Installation Guide” for installation procedures of the device
drivers.