ADLINK PXI-7921 - Manual (Page 11)

Installation • 5
2
Installation
This chapter describes the installation process for the ADLINK switch module.
Please read the contents of the package and the disassembling information
carefully as they are important in the implementation of the ADLINK switch
module.
2.1 Contents
The package consists of the following items in addition to the User Manual:
• PXI-7921, 24-CH Multiplexer DPDT Relay module
• This User’s Guide
• ADLINK Software CD
• ADL-Switch User’s Guide
If any of these items are missing or broken, please do not hesitate to contact
ADLINK or the dealer from whom the product was purchased. Keep the
shipping materials and carton for future storage or shipping.
2.2 Unpacking
ADLINK switch module contains sensitive electronic components that can be
easily damaged by static electricity. The switch module should be operated on a
grounded anti-static mat. It is strongly recommended that the operator wears an
anti-static wristband, grounded at the same point as the anti-static mat.
Inspect the box for any obvious damage. Check the unit to ensure there are no
shipping and handling damages that may have occurred before proceeding.
After opening, remove the system module and place it only on a grounded anti-
static surface component side up.
Again, inspect the module for any damage. Press down on all the socketed IC’s
to make sure they are all properly seated. Please do this only on a firm and flat
surface.