ADLINK cPCI-3544 User Manual
Page 28
22
• Installation
2.4 Hardware Configuration
The serial communication module has Plug and Play component, the card
can requests memory usage (I/O port locations) of the card which is
assigned by system BIOS. The address assignment is done on a
board-by-board basis for all serial communication cards in the system.
The jumper SW1-1 for cPCI-3534 and the JP1 for cPCI-3538 is used for
the system to recognize the first or second card of the same model in the
system if there are two of the same cards on the board.
The SW1-3 for cPCI-3544 is used for the system to recognize the card
number of the same model in the system if there are more than two cards
of the same on board.
2.4.1 Wiring
Example
You can use the C425M and C409M for wiring. Please refer to Chapter 1
for pin assignment.