ADLINK cPCI-3615 - Manual (Page 70)

56 Getting Started
2. Remove the DB-3UMC daughter board by unscrewing
the four screws as shown below.
3. There is a 3.3V key on board by default, if the PMC/XMC
card you wish to install is 5V signaling, please remove
the key and set the PMC V(I/O) jumper JPX2 to the 5V
setting.
4. Align the male connectors of the PMC/XMC card (com-
ponent-side down) to the female connectors of the
DB-3UMC and press down.
3.3V Key
This page intentionally left blank.