ADLINK cPCIS-2500 Series - Manual (Page 15)

Getting Started • 9
2.3 Powering Up the System
Set the main power switch in the lower right corner of the rear panel to the off
position ( O ). Set the secondary power switch in the lower right corner of the
front panel to the off position ( I ). Connect the supplied power cord to the
socket on the back of the chassis. The supplied PSU is full range 90-240VAC
and does not require input voltage setting. Insert a system module and any
desired peripheral cards into the appropriate card slots.
To power up the system, set the secondary power switch on the front panel
to the on position ( II ).