ADLINK LEC-iMX6 - Manual (Page 14)

10 Hardware
2 Hardware
2.1 CPU
The LEC-iMX6 product family offers four models of the Freescale™ i.MX6 CPU: the i.MX 6Solo
(1x Core), the i.MX 6Dual (2x Core), the i.MX 6DualLite (2x Core, single-display, no SATA), and
the i.MX 6Quad (4x Core). i.MX6 CPUs feature 64-bit/32-bit ARM Cortex-A9 processor cores
built on 40-nanometer process technology. The CPUs are designed for one-chip platforms, all
using the same package, and are pin compatible. Refer to the CPU data sheet and reference
manual at:
http://www.freescale.com/webapp/sps/site/taxonomy.jsp?code=IMX6X_SERIES .
2.2 Memory
The LEC-iMX6 employs one channel of 64-bit DDR3L on-board memory. Four SDRAM memory
chips provide up to 16Gb of non-ECC, unbuffered, low voltage system memory. Refer to the
SDRAM datasheet at:
http://www.micron.com/parts/dram/ddr3-sdram/mt41k256m16ha-125-it
2.3 eMMC NAND Flash
The module supports an optional on-board eMMC (Multi-Media Card) NAND chip with capacity
up to 64GB and can be used as the Boot device.The data signals are routed from the NAND
chip through the SDMMC pins on the SMARC connector. If the optional eMMC NAND chip is
present on the module, the eMMC interface will not be available for the baseboard on the
SMARC connector. Refer to the NAND Flash datasheet at:
http://www.micron.com/parts/nand-flash/managed-nand/mtfc8gldea-4m-it