ADLINK LEC-iMX6 - Manual (Page 24)

20 Power and System Management
NOTE: The gray table cells denote ground.
5 Power and System Management
5.1 SEMA Utility
Under the management of the BMC chip (Board Management Controller), the SEMA utility
(Smart Embedded Management Agent) provides system control and failure protection—count-
ing, monitoring, and measuring hardware and software events, from which the SOC can trigger
corrective commands. The optional SEMA Cloud utility not only controls local events on the
module but system client events on the IoT.
5.2 On-Board Power Supply
The on-board power supply generates all necessary voltages from the single supply voltage
range of 3V to 5.25V DC.
Externally, +5V Standby can be used instead of the on-board generated +5V Standby voltage.
5.3 System States
The following system states are supported: Suspend to RAM, Freeze, and Standby.
5.4 External Power Button
The board provides support for a power button to initiate transition from Off to On and On to Off
(hold for 4 seconds to power off.)
5.5 Reset-In Signal
The board provides support for a reset button to restart the system.
5.6 External Battery
The module supports an external RTC that is powered by a battery on the baseboard.
30 RST# LPC Debug Card
31 Not Connected
32 Not Connected
33 LPC_3V3 LPC Debug Card
34 SPI_U-BOOT_CLK SPI Program
35 SPI_U-BOOT_MOSI SPI Program
36 SPI_U-BOOT_MISO SPI Program
37 SPI_U-BOOT_CS1# SPI Program
38 SPI_U-BOOT_CS0# SPI Program
39 GND
40 VCC_SPI_IN SPI Program
Table 4-2: Debug Interface Signals (CN2) (Continued)