ADLINK MXE-200i User Manual
Mxe-200 series, Advance technologies; automate the world
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- MXE-200 Series
- Preface
- Table of Contents
- List of Tables
- List of Figures
- 1 Introduction
- 2 Getting Started
- 3 Driver Installation
- Appendix A Watchdog Timer (WDT) & DI/O Function Libraries
- Appendix B BIOS Setup
- B.1 Main
- B.2 Advanced
- B.2.1 CPU Configuration
- Limit CPUID Maximum
- Execute Disable Bit
- Intel Virtualization Technology
- Power Technology
- B.2.2 SATA Configuration
- Serial-ATA (SATA)
- SATA Speed Support
- SATA Mode
- Serial-ATA Port 0
- SATA Port0 HotPlug
- B.2.3 USB Configuration
- Legacy USB Support
- XHCI Hand-Off
- EHCI Hand-Off
- USB Mass Storage Driver Support
- USB transfer time-out
- Device reset time-out
- Device power-up delay
- B.2.4 SDIO Configuration
- SDIO Access Mode
- B.2.5 Network Configuration
- Network Stack
- B.2.6 Baytrail Feature Configuration
- LPSS & SCC Devices Mode
- SCC SD Card Support
- DDR50 Support for SD Card
- MIPI HSI Support
- LPSS HSUART # Support
- HSUART Port Mode
- B.2.7 ACPI Setting
- Enable ACPI Auto Configuration
- Enable Hibernation
- ACPI Sleep State
- Lock Legacy Resources
- B.2.8 Thermal Configuration
- Critical Trip Point
- Passive Trip Point
- Active Cooling Trip Point
- B.2.9 Security Configuration
- TXE
- TXE HMRFBO
- TXE Firmware Update
- TXE EOP Message
- TXE Unconfiguration Perform
- B.2.10 Miscellaneous Configuration
- OS Selection
- B.3 Security
- B.4 Boot
- B.5 Exit
- Important Safety Instructions
- Getting Service