ADLINK NuPRO-E42 - Manual (Page 40)

28 Getting Started
Install the Windows operating system before installing any driver.
Most standard I/O device drivers are installed during Windows
installation.
2.4.1 Intel ® Q87 Express Chipset Driver
This section describes the installation of the Intel® Q87 Express
chipset driver.
1. Locate the directory X:\NuPRO\NuPRO-E42\Chipset\
on the ADLINK All-in-One DVD, run the program
infinst_autol.exe and follow the onscreen instructions.
Restart the system if prompted.
2.4.2 Display Driver
Integrated Intel® HD Graphics
This section describes the driver installation for the Integrated
Intel® HD Graphics.
Follow these instructions to install the display driver:
1. Locate the directory X:\NuPRO\NuPRO-E42\VGA\64
Bit\ on the ADLINK All-in-One DVD, and extract the con-
tents of the following archive: Win64.zip
2. Run the program setup.exe and follow the onscreen
instructions. Restart the system if prompted.
2.4.3 Ethernet Driver
Follow these instructions to install the Ethernet driver.
1. Locate the directory
X:\NuPRO\NuPRO-E42\Ethernet\Windows\64\ on the
ADLINK All-in-One DVD, run the program PROWinx64.exe
Management
Engine
\NuPRO\NuPRO-E42\Others\ME_Driver\
WARNING:
In order to enable RAID or AHCI mode, you must pre-install the
Intel® Rapid Storage Technology driver during the Windows* instal-
lation process. using the F6 installation method.
*Not required for Windows Vista and Windows 7.