ADLINK NuPRO-A331 - Manual (Page 50)

36 Getting Started
3.4 Installing the Power Connectors
Refer to Section 2.2 Board Layout on page 18 and Section 2.3
Onboard Connectors on page 19 for detailed information on con-
nectors and pin definitions referred to below.
ATX 12V Power Connector
The NuPRO-A331 requires +12V DC power connected to CN1 for
proper operation in either ATX or AT modes. If necessary, order a
ATX12V Convert Cable from ADLINK for use with Molex 4-pin
power connectors (P/N 30-00006-0000).
Front Panel Connector
Before powering up the NuPRO-A331, connect the necessary sig-
nals from the backplane to the System Panel pin header (CN27).
The ATX Power Connector pin group (pins 6, 8, 9, 10) and Power
Button pin group (pins 19, 20) must be connected for the system
to power up in ATX mode.