ADLINK NuPRO-A331 - Manual (Page 55)

Driver Installation 41
NuPRO-A331
4.8 Audio Driver
Follow these instructions to install the audio driver for the optional
DB-Audio2 daughter board.
1. Place the ADLINK All-in-One DVD to the optical drive.
2. Locate the audio driver from the directory
X:\Audio Daughter Board\DB-Audio2\, then dou-
ble-click on the setup.exe file to start installation.
3. Follow the screen instructions to complete installation,
then restart the system if prompted.
4.9 Management Engine
After installing all required drivers, Windows Device Manager will
show one device without a driver: PCI Simple Communications
Controller. This device is the Intel Active Management Technol-
ogy Management Engine. Intel Active Management Technology is
not supported by the NuPRO-A331, but the driver can be installed
in order to remove the “question mark” from the Device Manager.
Follow these instructions to install the Intel® Active Management
Technology driver.
1. Locate the directory
X:\NuPRO\NuPRO-A331\Others\ on the ADLINK All-in-One
DVD, and extract the contents of the following archive:
Intel_Management_Engine_Interface_SOL_driver_
All_WinOS.zip.
2. Run the program
\ME_Drivers\MEI_SOL_Installer\Setup.exe and follow
the onscreen instructions. Restart the system if
prompted.
NOTE: NOTE:
Before installing the audio driver, check the BIOS settings to
make sure that audio is enabled: Chipset > PCH Configura-
tion > HDA Controller (see “PCH Configuration” on
page 70).