ADLINK AmITX-IB-I - Manual (Page 36)

24 Getting Started
3.3 System Memory
The AmITX-IB-I supports up to 16 GB of DDR3-1066/1333
SDRAM in two 204-pin SO-DIMM sockets. See Figure 2-1 on
page 7 for SO-DIMM socket locations.
Memory Module Installation
The DDR3 memory modules are notched to facilitate correct
installation in the DIMM sockets.
To install a memory module:
1. Unlock the SO-DIMM socket by pressing the retaining
clips outward.
2. Align the memory module on the socket, making sure that the
notch matches the break on the socket.
WARNING:
Disconnect all power supply to the board before installing a
memory module to prevent damaging the board and mem-
ory module .
DDR3 SO-DIMM Notch
Unlocked retaining clip