ADLINK AmITX-IB-I - Manual (Page 41)

BIOS Setup 29
AD-mITX-T40H
4 BIOS Setup
4.1 Introduction
This section explains how to use the UEFI Setup Utility to
configure your system. The UEFI chip on the motherboard stores
the UEFI Setup Utility. You may run the UEFI Setup Utility when
you start the computer. Please press <F2> or <Del> during the
Power-On-Self-Test (POST) to enter the UEFI Setup Utility,
otherwise POST will continue with its test routines.
If you wish to enter the UEFI Setup Utility after POST, restart the
system by pressing <Ctl> + <Alt> + <Delete>, or by pressing the
reset button on the system chassis. You may also restart by
turning the system off and then back on.
4.1.1 UEFI Menu Bar
The top of the screen has a menu bar with the following selec-
tions:
X Main
: To set up the system time/date information
X Advanced
: To set up the advanced UEFI features
X Chipset
: To set up advanced chipset features
X Boot
: To set up the default system device to locate and load
the Operating System
X Security
: To set up the security features
X Exit
: To exit the current screen or the UEFI Setup Utility
Use the < ← > key or < → > key to choose between the selections
on the menu bar, and then press <Enter> to get into the sub
screen. You can also use the mouse to choose your required item
by clicking.
NOTE: NOTE:
Because the UEFI software is constantly being updated, the
following UEFI setup screens and descriptions are for refer-
ence purposes only, and they may not exactly match what you
see on your screen.