ADLINK MI-220 - Manual (Page 22)

10 Introduction
Table 1-3: MI-220 Board Layout Legend
Figure 1-3: MI-220 Rear I/O Layout
AAFP1
Front Panel Audio pin
header
JLPC1
LPC pin header
ATXPWR1 ATX Power connector JLVDS1
LVDS Flat Panel
connector
COM1~4
Serial Port connectors
JPSON1
AT Mode jumper
CPU_FAN1
CPU Fan connector
KBMS1
PS/2 KB/MS pin header
DIMMA1 SO-DIMM Channel A PCI1 PCI slot
DIMMB1
SO-DIMM Channel B
PCIEX16_1
PCIe x16 slot
DIO1
Digital IO pin header
SATA1/2
SATA 6 Gb/s connectors
F_PANEL1
System Panel pin header SATA3 SATA 3 Gb/s connector
JBKL1
LCD Inverter connector
SPDIF_OUT
S/PDIF pin header
JCASE1
Chassis Intrusion
connector
SPI_CN1
SPI pin header
JCLRT_C2
LCD Backlight Voltage
jumper
SYS_FAN1
System Fan connector
JCMOS1
Clear CMOS jumper
USB45
USB4/5 pin header
NOTE: NOTE:
The HDMI port has limited clearance with the rear I/O shield.
Use an HDMI cable with a low-profile molding.
Audio USB HDMI VGA
DVI LAN1 LAN2