ADLINK MI-220 - Manual (Page 25)

Connectors & Jumpers 13
MI-220
2 Connectors & Jumpers
Refer to Figure 1-2: MI-220 Board Layout and Figure 1-3: MI-
220 Rear I/O Layout
for connector and jumper locations.
2.1 Rear I/O Connectors
VGA Connector.
HDMI Connector
Signal Name Pin # Pin # Signal Name
Red 1 2 Green
Blue 3 4 VCC pull-up
GND 5 6 GND
GND 7 8 GND
VCC 9 10 GND
VCC pull-up 11 12 DDC2B DATA
HSYNC 13 14 VSYNC
DDC2B CLK 15
Pin # Signal Pin # Signal
1 TMDS Data2+ 2 TMDS Data2 Shield
3 TMDS Data2– 4 TMDS Data1+
5 TMDS Data1 Shield 6 TMDS Data1–
7 TMDS Data0+ 8 TMDS Data0 Shield
9 TMDS Data0– 10 TMDS Clock+
11 TMDS Clock Shield 12 TMDS Clock–
13 CEC 14 Reserved
15 SCL 16 SDA
17 DDC/CEC Ground 18 +5 V Power
19 Hot Plug Detect
NOTE: NOTE:
The HDMI port has limited clearance with the rear I/O shield.
Use an HDMI cable with a low-profile molding.