Mc (military connector) pin definitions, Table 6, I/o panel connectors – ADLINK MilSystem 735 User Manual
Page 13: Table 7, Mc-1 connector pin signals
MilSystem Setup
MilSystem
User’s Guide
9
Table 6. I/O Panel Connectors (Refer to
for connector locations.)
MC (Military Connector) Pin Definitions
The following three tables break down the signals of the three military I/O connectors (MC) on the
MilSystem. Each table lists the MC pin number, the mating breakout cable connector, the breakout cable
connector pin number, and the signal name and description of each pin on the military connector.
Control/Connector
Description
MC-1
This military connector provides signals for VGA, Ethernet, PS2 Keyboard,
Stereo Audio Out, Stereo Line In, Mic In, ACPI Power In, Reset In, Power On
LED, HDD Activity LED, SATA, USB 2.0.
MC-2
This military connector provides signals for USB 2.0, Ethernet, and RS232/
485/422 COM Ports.
MC-3
This military connector provides signals for Parallel and LVDS.
DC Power In
This Military Power connector accepts DC voltages from an external source. This
connector is available in two versions depending on the MilSystem model:
•
The MILxxx models provide +12VDC to +25VDC power connectors.
•
The MILxxxW models provide +14VDC to +32VDC power connectors.
NOTE
This connector is manufactured by Amphenol,
P/N PT06E-8-4S(023).
NOTE
To connect a Hard Disk Drive (HDD) or CD-ROM to the MilSystem, use
one of the USB or SATA ports to connect the device.
Table 7. MC-1 Connector Pin Signals
MC
Pin #
Breakout Cable
Connector
Breakout
Cable Pin #
Signal
Signal Description
1
VGA
1
RED
Red Analog Output
2
VGA
6
GND1
Ground
3
VGA
2
GREEN
Green Analog Output
4
VGA
7
GND2
Ground
5
VGA
3
BLUE
Blue Analog Output
6
VGA
8
GND3
Ground
7
VGA
13
HSYNC
Horizontal Sync
8
VGA
10
GND4
Ground
9
VGA
14
VSYNC
Vertical Sync
10
VGA
9
PWR
Power
11*
VGA
12
SDA
Display Data Channel
(DDC) - Data
12*
VGA
15
SCL
Display Data Channel
(DDC) - Clock
NC
4
Not connected
NC
5
Not connected
V+
Ground
B
AD
C
8-4