ADLINK MilSystem 735 - Manual (Page 18)

MilSystem Setup
14 User’s Guide MilSystem
13 Parallel 13 SLCT Select - indicates the printer
is selected and powered on
if the signal state is High.
14 Parallel 14 AFD Auto Feed - requests the
printer to automatically
feed one line after each line
is printed.
15 Parallel 15 ERR Error - status output from
the printer, indicating an
error condition exists on the
printer if the signal state is
Low.
16 Parallel 16 INIT Initialize - used to initialize
the printer. Output in
standard Mode, I/O in ECP/
EPP mode.
17 Parallel 17 SLIN Select In – used to select
the printer. I/O pin in ECP/
EPP mode.
18 Parallel 18 GND Ground
19 Parallel 19 GND Ground
20 Parallel 20 GND Ground
21 Parallel 21 GND Ground
22 Parallel 22 GND Ground
23 Parallel 23 GND Ground
24 Parallel 24 GND Ground
25 Parallel 25 GND Ground
26 LVDS 1 VCC_12VP +12 volt input
27 LVDS 2 VCC_LVDS_CONN +3.3 volt or +5 volt input
28 LVDS 3 GND Ground
29 LVDS 4 GND Ground
30 LVDS 5 CLK_LVDS_IYBP Channel 2 clock positive
31 LVDS 6 CLK_LVDS_IYBM Channel 2 clock negative
32 LVDS 7 LVDS_IYBP3 Channel 2, line 3, data
positive
33 LVDS 8 LVDS_IYBM3 Channel 2, line 3, data
negative
34 LVDS 9 LVDS_IYBP2 Channel 2, line 2, data
positive
35 LVDS 10 LVDS_IYBM2 Channel 2, line 2, data
negative
36 LVDS 11 LVDS_IYBP1 Channel 2, line 1, data
positive
Table 9. MC-3 Connector Pin Signals (Continued)
Pin # Breakout Cable
Connector Breakout
Cable Pin # Signal Signal Description