Alwarerc Senrigan GP-25 Lite Brushless Gimbal - Manual (Page 18)

8. Power On Steps
Before Power On the Gimbal:
1. Double check the polarity of the Gimbal Power Cable which is soldered to the F450/550/Phantom's
power board or cable. Red = Positive, Black = Negative. (Incorrect polarity will damage the Brushless
Gimbal Controller!)
2. Double check the battery polarity before plugged in.
3. Make sure the camera is mounted securely and correctly.
4. Double check the CG of the gimbal with camera mounted.
5. The Brushless Gimbal Controller is preset to plug-n-play with GoPro camera. There is no
additional tuning needed normally.
Follow the following sequencies to power on your Senrigan GP-25 Brushless Gimbal correctly.
Step 1.
Place the F450/550 or Phantom with Senrigan GP-25 Gimbal Assembly on the ground and keep it steady during
the starting process.
Step 2.
Turn on your Aircraft transmitter, then connect the Battery
(must be 3S lipo) to the power cable of the Aircraft
and wait for around 15 seconds. IMU is now initialing. (Do not move the Gimbal during the initialisation
process, otherwise the Gimbal will fail to start!)
After the Initialization Process, the Tilt and Roll Motors will move slowly to the center position. The camera is
now in level position and ready to fly.
If the Gimbal fail to start as normal, reboot the power and try again.
(Remember never move the Aircraft and
the Gimbal during the Initialization Process.)
Step 4.
Ready to go!
Page 18 of 19