Alwarerc Senrigan GP-25 Lite Brushless Gimbal - Manual (Page 8)

Step 11.
Soldering the Power Cable of GP-25 with any
soldering point on the F450.
(Important: Red =
Positive, Black = Negative, make sure you are using
3S lipo 11.1V for F450 as well.)
Step 12.
Insert the Yellow&Black Connector(used to control
the Tilt axis) of the Tilt Roll Cable to the free channel
of your receiver (e.g. CH Gear), and assign a
potentiometer switch on your TX to control it.
Step 13.
Use the closer slots when mounting with Gopro3 Cam. Step 14.
Use the outer slots when mounting with Gopro2 Cam.
Step 15.
Mount your Gopro Cam onto the Gimbal. Next go for
the CG Adjustment section to adjust the CG of the
gimbal with the camera as to have stable performance.
Page 8 of 19