Trouble shooting guide – American Energy Systems MagnuM Baby Countryside User Manual

Page 37

Advertising
background image

37

TROUBLE SHOOTING GUIDE

Unplug power to the appliance before performing any service.

PROBLEM

CAUSES

SOLUTIONS


? Fire burns with a lazy, orange flame
and/or fuel builds up in the firepot and
the window gets sooted up quickly.

♦ Insufficient combustion air.

♦ Feed rate too high for manual draft

setting.

♦ Wood pellets / Corn have too much

moisture, have too many fines, too
high of ash content or are old.

♦ Combustion/Exhaust blower / heat

exchanger plugged.

♦ Venting plugged with fly ash or ice.

♦ House does not have adequate

make up air (negative pressure)

♦ Ash Slides are pulled out

9 Remove any clinkers or ash from

the firepot by using scraping tool.
Clean entire system.

9 Clean out primary air in firepot

holes if plugged.

9 Empty ash drawer and clean out

heat exchangers by removing the
access plates.

9 Change to a better grade of fuel if

necessary.


9 Check that damper control knob is

adjusted properly. Pull out to
increase fire burn.

9 Push ash cleanout slides in
9 Check gasket seal around the door.

If the door is loose, adjust the
handle latch. A small adjustment
can be made to the door seal by
adjusting the door latch rod and /or
the door hinges. Replace the door
gasket if necessary.

9 Check for blockage in the air inlet

tube or exhaust pipe. Clean out as
necessary.

9 Check combustion exhaust blower

impeller. This can be done by
removing the exhaust pipe and
shining a light into the tube or using
the access plug on the exhaust
manifold side plate.

9 Replace combustion exhaust blower

if necessary.

NOTE: Negative pressure in a home is
a serious issue. All Magnum appliances
should be installed with outside air
hookups

Also make sure that adequate ventilation
is supplied for the rest of the home or
the unit will become the air intake
causing problems.

Advertising