AMT Datasouth Accel 7450 - Manual (Page 13)

ACCEL- 7450
- 13 -
3.
Slide the paper path lever to the cut sheet symbol.
Note: The printer in this mode will automatically load cut sheet paper
about one (1) second after a sheet is fully inserted in the manual input
paper slot.
4 .
Insert a cut sheet paper straight along the LEFT paper guide. Make sure
the paper is inserted as far as it will go and that it is square to the feed
rollers. The printer beeps one time then feeds the sheet in. NOTE: The
delay period can be adjusted by setting Control Panel menu item #36
LOAD DELAY.
LEFT paper guide
Cut sheet paper will NOT load unless the printer’s
reflective photo sensor sees the back of the sheet
about 1 ¾ inches (44.45 mm) in from the leading
edge.
This sensor’s horizontal location is around the 25mm
(approx 1 inch) mark on the printer ruler.