AMT Datasouth Accel 7450 - Manual (Page 15)

ACCEL- 7450
- 15 -
Installing the Rear Tractor
1.
Snap the black plastic paper guides onto the tractor assembly if
they are not already in place. The curved ends point away from the
printer.
2.
Make sure the printer power is off. Plug the cable from the tractor
into the connector at the back of the printer.
3.
Insert the top slot in the tractor brackets onto the top printer pins.
Allow the bottom bracket slots to rest on the bottom printer pins.
The tractor brackets do not snap in place.
WARNING! Make sure the tractor brackets are fully seated in the bottom
pins. Cut sheet forms may jam on the tips of the tractor paper guides if the
tractor brackets are not seated.