AMT Datasouth Accel 7450 - Manual (Page 40)

ACCEL-7450
- 40 -
15. The last characters of a line are printing on the next line below and at the far
left of cut sheet forms.

Verify menu item # 7 RIGHT PAGE WDTH is set to NO. This is the factory
default value.

Move the left paper guide so the paper loads further to the left by at least
the number of characters printing on the wrong line. Maximum print line
width is attained when the left edge of the paper is aligned to
approximately 8 mm to the left of the zero (0) position on the ruler molded
into printer cabinet.

Make sure the line being printed fits within a space of 13.6 inches on the
paper. This is as wide as the printer can print. Example: 136 characters
maximum at 10cpi or 163 characters maximum at 12cpi.
Note. If the paper is too narrow for the data, the printer will print off the right
edge of the paper onto the platen. If printing exceeds the rightmost printing
capability of the printer (approximately the 340 mm position on the ruler molded
into printer cabinet), surplus characters are automatically printed on the next
line (the text wraps).
16. Unit continues to print previous job.

Press ALT+RESET to clear any pending data.
W
h
e
n