Angelcare AC401 Deluxe - Manual (Page 10)

OUT-OF-RANGE ALARM
• Alarm activates when your two units are not communicating.
• The parent Unit will emit a double beep every 8 seconds.
• Out of Range Icon will flash on the screen.
IMPORTANT
If the Out-of-Range function is activated and you turn the Nursery Unit Off the
Out-of-Range Alarm will sound and/or vibrate (depending on the alarm mode chosen).
Turn the Nursery Unit ON again to reactivate the link.
TO STOP THE OUT-OF-RANGE ALARM:
press 2 seconds
to turn the parent
Unit Off
OR Turn the Nursery
Unit ON
The Out-of-Range will flash
when changing the channel
or if the unit is reconnecting.
TO TEST SOUND:
Ask someone to speak into the Nursery
Unit or place the unit near a radio to ensure
that sound is being picked up.
IF YOU HEAR NO SOUND:
• check that both units are switched ON.
• check that both units are plugged into
functioning electrical outlets.
• check the batteries in both units
(replace or recharge them as necessary
per unit).
• Bring the parent Unit closer to the
Nursery Unit.
IMPORTANT
To avoid feedback (whistling), keep
both units at least 3 meters apart.
5.5 - SOUND TRANSMISSION (VOX)
TO STOP THE ALARM
Turn the Nursery Unit sensitivity dial
from less sensitive (0) to very
sensitive (5).
NOTE:
If you are receiving false alarms,
adjust the sensitivity level.
TO ADJUST SENSOR PAD SENSITIVITY LEVEL:
IMPORTANT
• The Sensor pad is not designed for use with adults, children or infants older
than 24 months.
• Once you are finished using the Sensor pad, please remove it from the baby’s
crib and store it away.
for optimal results begin with the
sensitivity level dial on the 3
rd bar,
adjusting the sensitivity by half a bar
increases or decreases as required.
place your hand
back on the
mattress. press
any key
to put on
Hold (see
section 5.8)
Shut the Nursery
Unit Off
OR OR
5.4 - OUT OF RANGE FUNCTION
TO ACTIVATE THIS FUNCTION:
1
2
ON
Off
1) press MENU button 2 times.
The Out-of-Range Indicator
will blinks.
2) Using the arrows, turn the function
ON or OFF.
3) press SELECT button to confirm
your choice.
Your monitor has an Out-of-Range function that advises you when your two units
are not communicating. Out-of-Range situations can be caused by distance or
by physical interferences.
RANGE:
Up to 250 meters (open field).
Your monitor is ‘Sound Activated’. This means that it will transmit sounds only when it
detects them. It will detect even the softest levels of crying.
To save power, after 10 seconds, the sound transmission will stop if no sound is detected.
Once sound is detected transmission will automatically activate.
19 18