Angelcare AC401 Deluxe - Manual (Page 8)

SOUND TRANSMISSION (VOX)
Nursery Unit:
Appears when options are being set
for the Nursery Unit
Out-of-Range:
Indicates the lost of connection
between the parent Unit and
Nursery Unit.
Parent Unit:
Appears when options are being set
for the parent Unit
Temperature Display:
Indicates room temperature
Low Temperature:
Appears when low temperature
alert is ON
High Temperature:
Appears when high temperature
alert is ON
Channel Display:
Indicates selected channel
Alarm mode icons:
Indicates selected alarm mode
Sound alarm Only
Sound alarm
and vibration
Vibration Only
Volume/VOX sensitivity Level:
Indicates the volume and
VOX sensitivity level.
IMPORTANT ICONS
Detection mode icons:
Indicates selected detection mode:
Movement Only
Sound Only
“TIc”, Sound & Movement
Sound & Movement
“TIc” & Movement
Battery Level icon:
Indicates battery level
Empty
1/2 full
full
charging
STEP 4 - TURNING ON YOUR MONITOR
1) press the parent Unit ON/OFF button
for 2 seconds.
2) Slide ON the Nursery Unit power
ON/OFF button.
NOTE:
The screen of the parent Unit will show the
channel of transmission (c1 to c8) and after
5 seconds the room temperature and
function icons.
The connecting process should be done
within 30 seconds. If longer, the operation
will be ignored and you will have to start over.
CHANNEL SELECTION
1 2
When parent Unit is turned ON
and Nursery Unit is Off:
• No channel icon will
appear and Nusery Unit
icon will blink.
• Parent Unit will start
beeping after 1 minute.
5 seconds after beeping,
unit will shut itself off.
1) press and hold the select button
to enter channel mode.
2) pressing either the Up or DOWN arrow
will change the channel your monitor
transmits on (c1 to c8).
3) press the select button again to
confirm your channel selection.
NOTE :
If the transmission is not clear, or if you hear
interference sounds, you should change
the channel.
1
2
3
TO SELECT THE CHANNEL:
If there is a lost connection
between the 2 units
(refer to troubleshooting):
• The Out-of-Range icon will
blink on the screen and the
parent Unit will beep.
15 14