Denon AVR-3808 - Manual (Page 19)

- 19 -
Z3 COMMAND : "*" parameter uses two ASCII characters. (see page4 J) section)
Except Japan model
COMMAND PARAMETER function example
Z3 PHONO MULTI ZONE-3 mode set , and select source at AVR-3808 Z3PHONO<CR>
| ---The name of PARAMETER is |
IPOD the same as that of the time of SI COMMAND. Z3IPOD<CR>
SOURCE MULTI ZONE-3 mode cancel Z3SOURCE<CR>
UP MULTI ZONE-3 VOLUME UP/DOWN , direct change to **dB Z3UP<CR>
DOWN Z3DOWN<CR>
** **:10 to 99 by ASCII , 80=0dB, 99=---(MIN) Z380<CR>
ON MULTI ZONE-3 ON/OFF change at AVR-3808 Z3ON<CR>
OFF Z3OFF<CR>
? Return Z3 Status Z2?<CR>
Z3MU ON ZONE3 OUTPUT MUTE ON/OFF change Z3MUON<CR>
OFF Z3MUOFF<CR>
? Return Z3MU Status Z3MU?<CR>
Z3CS ST ZONE3 Channel setting Z3CSST
MONO Z3CSMONO
? Return Z3CS Status Z3CS?
Z3CV FL UP ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB Z3CVFL UP<CR>
FL DOWN ---FRONT Lch Z3CVFL DOWN<CR>
FL ** **:38 to 62 by ASCII , 50=0dB Z3CVFL 50<CR>
FR UP ZONE3 CHANNEL VOLUME UP/DOWN , direct change to **dB Z3CVFR UP<CR>
FR DOWN ---FRONT Rch Z3CVFR DOWN<CR>
FR ** **:38 to 62 by ASCII , 50=0dB Z3CVFR 50<CR>
? Return Z2CV Status Z3CV?<CR>
Z3HPF ON ZONE3 HPF ON/OFF Z3HPFON<CR>
OFF Z3HPFOFF<CR>
? Return Z3HPF Status Z3HPF?<CR>