Bonaire Slimline Digital controller - Manual (Page 7)

Multi-Appliance Slimline Control
Bonaire Control Systems Page 7
Navigating the Controls
FEATURES OF THE SLIMLINE CONTROLLER
1. Temperature Sensor: The Slimline Controller has an on
board
temperature sensor for room temperature
measurement.
2. LCD: The LCD shows different information depending on the
functions in use. The LCD usually shows only those items
relevant to the appliances you have installed. It will display
the room temperature (“ROOM”), set temperature (“SET”),
timer count and modes of operation (AUTO, MAN, FAN).
3. LEDs: The Slimline Controller provides 5 green LEDs for
status display of operation.
•
On/Off LED
•
Timer LED indicates that the timer is active.
•
Heat LED indicates heat mode.
•
Fan LED indicates fan mode.
•
Cool LED indicates cooling mode
4. 5 Soft Touch Buttons: The following explains the function of
each button,
•
ON/OFF: Press the ON/OFF button to turn the
Heating/Cooling unit ON or OFF. The ON/OFF LED is
on in the “On” state and off in the “Off” state.
•
MODE: The Mode button will allow you to operate
different modes of operation. Each press of the Mode
button cycles through the available modes. The table
below shows the modes presented by appliance,
•
TIMER: The Timer button allows the user to delay either
turning off or turning on the unit. If the Timer is active,
press the Timer button again to cancel the Timer
function.
•
UP/DOWN: Press Up/Down button to increase/decrease
the fan, timer or temperature settings.
Appliances Modes Presented
Heater Heat, Fan
Evaporative Cooler Auto Cool, Manual Cool, Fan
Heater with Evaporative Cooler Heat, Auto Cool, Manual Cool, Fan