Bonaire Series C - Commercial / Industrial - Manual (Page 14)

I NSTALLATION , O PERATION & M AINTENANCE
Commissioning
F AN O PERATION
• Check that pulleys are correctly
aligned.
• Check the belt tension is correct.
Nominally 15 – 20mm
depression.
• Check bearings are tight on shaft
• Check bearings are packed with
grease.
• Set the fan running and check.
• Check that the air is being evenly
distributed through the ductwork.
• Make adjustments, as required, to any manual
air dampers that may be fitted.
• Fan Motor Current. Check the motor
operating current is not greater the rating plate
value.
o For systems with high statics and
non standard drive check motor
current. Where required, review
pulley requirements relative to the
system static. Where variable pitch
pulleys are fitted adjust accordingly.
o For systems with minimal static e.g.
straight dropper and plenums,
check motor current. A smaller
motor pulley to standard may be
required.
C ONTROLS
Check all control functions are working
C USTOMER HAND O VER
Instruct the customer in the use of the product.
• Controls
• Bleed
off
• Venting the air via the side of the premises the wind is not blowing from.
• Maintenance
Requirements
Hand over of the customer’s operational manual.
Page 14 Bonaire Commercial / Industrial EAC