Bonaire Series C - Commercial / Industrial - Manual (Page 10)

I NSTALLATION , O PERATION & M AINTENANCE
Water Connections
Bonaire Commercial / Industrial EAC
Dump Valve (Optional)
• Where a Dump Valve is to be fitted, the
solenoid MUST be installed in series on the
unit side of the water-isolating tap.
• Fit the black pressure tube between the
dump valve and the solenoid valve.
• The 24V solenoid will be supplied with an
in-line transformer for 240V connection.
• Connect the 240V solenoid transformer
leads in parallel with the pump
terminations.
Or
Connect to a timed / delay independent
circuit supplied by the installer.
• The tank in the unit will only fill once power
has been applied to the solenoid valve
transformer and pressure through the black
tube has closed the dump valve.
Drain
The combination drain/overflow pipe outlet must be connected to a drainpipe, which has
sufficient capacity to take the discharge of water from the reservoir. The pipe must
connect to a suitable waste point.
Note: Refer to local regulations to ensure discharge of drain / overflow water is in
accordance with statutory requirements.
40mm Version 50mm Version
Page 10