Chicago Gaming Vacation Pinball - Manual (Page 6)

6
4) GAME SETUP
Step 1:
DO NOT
REMOVE
PLASTC
WRAP
4 legs
8 bolts
Position box vertically
Open the box; remove the legs and the
game hardware bag containing bolts.
Unwrap the 4 legs and take the 8 bolts from
the game hardware bag.
Lay the box on its side, slide the game out of
the box and position the game vertically.
Step 2: Attach front legs
DO NOT
REMOVE
PLASTC
WRAP
1 inch
DOWN
Using two leg bolts per leg, attach the two
front legs to the front of the main cabinet.
The leg bolts will require a 5/8” wrench to
tighten them. Tighten the bolts so that they
are snug but do not over tighten. The bolts
should be “wrist tight”, which is as tight as
you can comfortably turn a wrench using
only your wrist. Over-tightening bolts can
damage cabinet.
Step 3: Attach rear legs
DO NOT
REMOVE
PLASTC
WRAP
Tilt the game forward so front legs are on
the floor.
With one or two assistants, lift the back end
of the machine off the floor, and place it on a
stool or chair.
Attach the rear legs using two bolts per leg.
DO NOT OVERTIGHTEN!