Chicago Gaming Vacation Pinball - Manual (Page 8)

8
Step 7: Level the Machine:
leveler
leg
Place a carpenter’s level on the inside of the
bottom of the cabinet.
Adjust the leg leveler until the machine is
level.
Step 8: Power On
Locate the line cord packaged in the game
hardware bag. First, securely plug the
female end of the cord into the outlet on the
back of the game. Then plug the male end
into a grounded wall outlet. We recommend
using a surge-protector.
Turn the game on by the main power switch.
This switch is located under the right corner
of the main cabinet (behind the front right leg)
on the bottom of the cabinet. It is in a
recessed hole. Flip the switch to the ON
position and verify the game powers up and
the score display lights, playfield light flash,
etc. Most games will take approximately 15
seconds to completely boot up and start.
Note: the front door must be closed for
machine to power up.
5) VOLUME ADJUSTMENT:
Volume is digitally adjusted during the game boot-up (start up) process. To adjust volume, turn
the game off, and then back on. Game will boot-up and the score display will eventually show
the volume adjustment for the game, which reads:
L FLIPPER FOR VOLUME
Press the left flipper button while the above message is shown on the score display. The game
will then show the current volume setting (factory default is “7”), and allow you to change it.