Chicago Gaming Putt! Championship - Manual (Page 12)

12
1. Remove the bolts that hold the Floor to the Monitor Cabinet and remove the 4 bolts that mount the
Green to the Floor. You can leave the Green connected to the Monitor Cabinet.
2. Pull the Floor away from the Monitor Cabinet and disconnect the Floor Power Cable, which runs
between the two cabinets.
3. Pull the handrail down to the ground so that the Floor is vertical. Put something on the ground to
protect the art and Handrail from being scratched.
4. Remove the 4 screws for the pair of lamps that you have to remove. Slightly lift each block so you can
see which one has the inverter. Unplug both sets of white cables that are plugged into the inverter.
5. You can now remove and service the lamp or inverter.
6. When reinstalling the lamps, you must first install the lamp WITHOUT the inverter and run that lamp’s
cable to the other lamp’s mounting hole, as shown below. Now put the block with the inverter in position
and connect both of the lamps cables to the inverter