Chicago Gaming Putt! Championship - Manual (Page 8)

8
Removal of Ball Mech Cabinet
If the cabinet is too wide to fit through a doorway with the Ball Mechanism Cabinet attached, it can be
easily removed and reattached.
1
2
3
4
To reattach the Ball Mech Cabinet,
just follow the previous steps in reverse order.
Open the top door and side
door on the Ball Mech
Cabinet.
Remove the Back Door and
disconnect the AC Wire
Harness and Ball Mech
Harness that run between
the Monitor Cabinet and
Ball Mech Cabinet.
Pull the disconnected
harnesses back into the Ball
Mech Cabinet and close the
doors. Lift the Ball Mech
Cabinet straight up 1 inch to
free it from the Ball Mount
Brackets, and then pull it
away from the Monitor
Cabinet. The Monitor
Guard Bar should still be
connected to the Control
Panel Cabinet
Remove the 2 bolts
connecting the cabinets, the
2 nuts connected to the
Monitor Guard Bar and the
plate where you removed the
nuts.