Cino PL680BT HC - Manual (Page 10)

9
Out-of-range Scanning
When the radio connection is established between scanner and remote host
device, the scanner will transmit each scanned data right after scanning the
barcode. However, the default of the scanner is unable to scan any barcode
data when it loses the radio connection with the remote host device.
If you enable the out-of-range scanning function, the scanner is able to
continue scanning barcode data while it is out of radio coverage. All scanned
data will be temporarily stored into the memory buffer until radio link resumed.
Enable Out-of-range Scanning
Disable Out-of-range Scanning ◆
In case of the scanner is out of radio coverage, you will hear 4 beeps in
descending tone to indicate the radio connection lost. The link indicators of
scanner will blink blue 3 times per 2 seconds. Once the scanner is back to
radio coverage, you will hear 4 beeps in ascending tone to indicate the radio
connection rebuilt and the link indicators of scanner will blink blue once per
2.5 seconds. At the same time, all stored scanned data will be transmitted
automatically right after the radio link is resumed.
Sleep Mode & Power Off
The scanner will enter “Sleep Mode” if the scanner is not used after the
user-defined time-out duration. The scanner can also be entered “Sleep
Mode" instantly by pressing the Function Key 1 twice (each time lasts more
than one second).
When the scanner is under sleep mode, it is preset to enter “Power Off”
automatically if it’s not woke up after time-out duration. You can power off the
scanner by pressing and holding the Function Key 1 for more than 3
seconds.
You can also have your scanner entered “Sleep Mode” or “Power Off” by
scanning the following “Sleep Mode” or “Power Off” command.
Sleep Mode
Power Off
If you would like to power on or wake up the scanner, please press the trigger
key.