Cino PL680BT HC - Manual (Page 5)

4
Use FuzzyScan in PAIR Mode
Ensure the battery is fully charged. Please refer to the section of
Preparation before Using for details.
Please choose your desired interface cable, then plug it into the host
interface port of the smart cradle and connect it to the host device.
Turn on the power of your host device.
Power on or wake up the scanner by pressing the Trigger key if the
scanner is power-off or in sleep state.
The scanner is pre-paired with the shipped smart cradle, so you will see
the link indicators of scanner blink blue per 2.5 seconds, and the central
indicator of the smart cradle light blue. If the scanner and smart cradle
are not paired, the status indicator of scanner and the side indicators of
smart cradle blink red and green alternatively (in “Uninstall” state).
Please follow step 6 to establish the connection.
Scan “PAIR mode” command. The status indicator of scanner will turn
steady red immediately.
Uninstall
PAIR Mode
Place the scanner onto the smart cradle, then you will hear one short
beep to indicate the pairing process is activated. The scanner will emit
continuous short clicks and the link indicators of scanner will flash blue
quickly during the pairing process. When you hear 4 beeps in ascending
tone, the pairing process is completed. You will see that the link indicators
of scanner blink blue per 2.5 seconds and the central indicator of the
smart cradle lights blue.
If the scanner pairing process failed or it’s not placed onto the smart
cradle within 20 seconds, you will hear 2 “Di-do Di-do” beeps to warn the
failure of pairing, the scanner will return to uninstall state automatically.
Scan the corresponding host interface quick set command to complete
the installation.
The default host interface of smart cradle is preset to USB HID. If you
want to set the host interface to USB COM, you have to install the
USB virtual COM driver into your host device before using the
scanner. Please visit CINO website to download the driver.
USB PS/2 RS232