Use fuzzyscan in pico mode – Cino PL680BT HC User Manual
Page 6
5
Use FuzzyScan in PICO Mode
Please choose your desired interface cable, then plug it into the host
interface port of the smart cradle and connect it to the host device.
Turn on the power of your host device.
Ensure the side indicators of the Smart cradle blink red and green
alternatively (in “Uninstall” state). If the Smart cradle is paired with other
scanners, please press and hold the paging/reset key of the smart cradle
for more than 5 seconds to un-pair all paired scanners. Then the smart
cradle will return to uninstall state automatically.
Prepare the scanners you desire to pair with the smart cradle. Power on
or wake up the scanner by pressing the Trigger key if the scanner is
power-off or in sleep state. Ensure the status indicator of each scanner
blinks red and green alternatively (in “Uninstall” state). If the scanner
is not in uninstall state, please scan the “Uninstall” command to un-pair
the scanner, then scan the “PICO mode” command, the status indicator
of scanner will turn to light red.
Uninstall
PICO Mode
Place the scanner onto the smart cradle, then you will hear one short
beep to indicate the pairing process is activated. The scanner will emit
continuous short clicks and the link indicators of scanner will flash blue
quickly during the pairing process. When you hear 4 beeps in ascending
tone, the pairing process is completed. You will see that the link indicators
of scanner blink blue once per 2.5 seconds, the central indicator of the
smart cradle lights blue and its side indicators light green.
If the scanner pairing process failed or it’s not placed onto the smart
cradle within 20 seconds, you will hear 2 “Di-do Di-do” beeps to warn the
failure of pairing, the scanner will return to uninstall state automatically.
Please scan the corresponding host interface quick set command to
complete the installation. Then repeat the same procedures to pair other
scanners with the smart cradle.
For user’s convenience, the smart cradle will automatically assign the
ID numbers to each scanner. Please scan the System Information
command to check the assigned ID number of each scanner.
USB
PS/2
RS232