Display Devices Lifts up up 75 lbs - Manual (Page 2)

13. Position new motor and bolt back into place. Tighten hardware.
14. Replace sprocket on motor shaft. Do not tighten setscrews until aligned.
15. Reinstall chain, connecting master link.
16. Align sprockets squarely and tighten Pillow Block bolts and sprocket set
screws on motor shaft – be sure the setscrew is on the Keystock.
17. Reinstall scissors – do not over tighten the nuts impeding the motion of the
scissor pivot.
18. Verify all hardware is tightened and recheck the alignment of all
components.
19. Remove the Duct Tape from the cable drum.
20. Remove any straps used to support the lower frame.
21. Adjust the wire rope cable.
22. Be sure all tools are clear within the lift.
23. Turn on power – run unit to the home position – cycle the lift a few times.
24. Check alignment and level.
25. Replace projector and closure system.
Front
Slot Sensor/wheel
(under frame)
Pillow Block
Pillow Block
alignment
adjustment
Motor Mount