Display Devices Motorized Rotating Ceiling Mounts - Manual (Page 2)

8/7/07 2
Programming Screen Positions:
6. To enter programming mode: Press and hold the Stop Button until the LED near the
remote plug flashes rapidly (about 4 seconds).
7. Press the Clockwise button and then press the stop button at the desired projection
position. You may go clockwise and counterclockwise to attain the desired position.
To memorize this position, simultaneously press and hold the Stop and Clockwise
buttons until the LED flashes rapidly (about 4 seconds).
8. Press the Counterclockwise button and then press stop at the desired position. Again
you can jog the unit in either direction until you attain the desired position. To
memorize this position, simultaneously press and hold the Stop and Counterclockwise
buttons until the LED flashes rapidly (about 4 seconds).
9. To exit the programming mode press and hold the Stop button until the LED flashed
rapidly (about 4 seconds).
10. Verify your clockwise position by pressing the Clockwise button. If the position is not
where you need it, simply rotate the mount to fine tune. After you have the final
position tighten the lock ring with a screwdriver and hammer.
11. Press Counterclockwise to rotate to your other screen position. If the position is not
accurate, reprogram the Clockwise position only by following steps 6, 8 and 9.
12. Connect control system cables as required. See Motor Control Interface for
connections.
MRCM Connections
AC Connection terminates in one attached junction box
(
be sure circuit power is off until wiring is completed )
1 Line AC Ground = Green
2 Line AC Hot = Black
3 Line AC Neutral = White
Contact Closure – the easiest and most popular control.
The standard controls (handheld remote) are three momentary buttons (contacts). For
AMX/Crestron control, attach your auxiliary control to the 5-pin Phoenix-style connector in
the side junction box opposite of AC power.
Pin 1 Black Clockwise
Pin 2 Red Counterclockwise
Pin 3 Green Stop
Pin 4 White Common for all buttons
Low-Voltage Control (5dc<V<24 vdc) Control Signal
This function requires removal of the access side panel to get to the control box.
Jumper from pin1 to pin 4 and pin 2 to pin 4
Trigger voltage to pin 5
Trigger voltage ground to pin 4